Pretty cut and dry. Judging by the fact that the app doesn’t show it re-downloading the pattern, a reasonable assumption is that it’s stored in a small amount of memory. One day I tried playing a pattern (bear), and it stopped about halfway through. Figuring it a blip, I moved on, and did a few more patterns. Later on I tried bear again, and once more it stopped partway through. Next, rather than move on, I tried redoing it from the start, and it stopped right where it previously had. However, after struggling through a factory reset, it was able to draw it properly. If deleting the pattern from memory through a reset allowed it to draw properly, then a simple button would make it a lot easier
Did the app report that the pattern was continuing, or did it stop on both the app and the Mini?
It stopped both and moved on to the next track
Thanks for the feedback. I’ll mention this to the devs.
I was seeing the same thing and had to do a hard reset. The issue started when I tried to load the crane pattern and it failed partway through. I wasn’t able to load any large patterns after that until I did the hard reset