I’ve submitted a support ticket, but also wanted to share the issues that I’ve been struggling with for the last few days.
Prior to the update, the Mini had begun to lose orientation (not knowing where center is), image was offset, and it seemed to only draw parts of an image.
Things got worse after the update. Setting off out-to-in spiral, it would hug the perimeter and never move inwards. In-to-out had it drawing only half the spiral. It’s as if the Mini thought the scale of the drawing surface was halved. Then after factory reset and re-pairing to WIFI, etc., it tried to draw a turtle and woo, it was not good.
In the photo, I had it draw a spiral first, then a turtle.