Clicking, chunky, hum... whisper quiet my behind

General
1

I’ve read the forum and am currently undergoing the “run the spiral overnight” to try to resolve the issues. But… damn. Disappointing. I had it running for a half dozen patterns on my dining room table at home; I took it elsewhere and put it on my desk beside me so I could watch… but it’s so loud it disrupts work.

I note as it runs the spiral inside-out that it hums LESS in two particular areas. If it was always like that it would be GREAT. The clicking also only happens within a repeatable section in a known quadrant.

WHOA. Just as I’m typing this, the spiral is about 1/3 done and the hum just… stopped.

I am hoping this resolves the issues because I want to love this thing.

2

Same for me. A lot of humming grinding noise in the center especially.

3

Ya the grinding noise makes me think this thing is not going to last. Something is eventually going to wear down and break down.

1 Like